Skip to content

New SIM: how to set it up and fix no signal

Updated 16 November 2026 · 4 minute read

The short answer

Put the SIM in, or install the eSIM, and restart the phone. Most SIMs work within minutes of activation. If there is no signal or data, restart again, turn airplane mode on and off, check mobile data is on and network selection is automatic, and make sure 4G calling is switched on.

When it arrives

  1. Wait for the message saying your SIM is active, if your provider sends one.
  2. Fit the SIM or install the eSIM, then restart the phone.
  3. Make a short call and load a web page with Wi-Fi off, to check calls and data both work.
  4. If you are moving your number, keep your old SIM in a drawer until the move completes.

No signal at all

  • Restart the phone. It sounds too simple, but it clears most first-day problems.
  • Turn airplane mode on for ten seconds, then off.
  • Check network selection is set to automatic, in Settings under Mobile or SIMs.
  • Check the phone is not locked to another network; a locked phone shows 'SIM not supported'.
  • Try the SIM in another phone. If it works there, the problem is the phone; if not, contact your provider.

Signal but no data

  • Make sure mobile data is switched on, and on for this SIM if the phone has two.
  • Turn off any VPN for a moment to rule it out.
  • Most phones set the access point (APN) automatically. If data still fails, your provider's help pages give the settings to enter.

Calls fail or drop

UK networks have switched off 3G, so calls now need 4G calling (VoLTE). Check it is on in your mobile settings. Very old phones without 4G calling may not make calls at all on some networks.

Indoors, turn on Wi-Fi calling as well, so calls use your broadband when the signal is weak.

This guide describes UK rules in general and is not legal advice. Rules change; the date above is when we last checked it against Ofcom's published guidance.

Join the launch list

when Phonezy